Mini ST-LINK/V2 on a small single board, an extreme low cost solution for in-circuit debugger/programmer for STM8 and STM32.
Features
? Onboard 500mA self-recovery fuse to avoid harming by short circuit
? Dual voltage output (3.3V/5V), easy for debugging/programming
? Standard USB interface for direct connection to PC
? Debugging/Programing performance
o Debugging : run at full-speed, single-stepped, breakpoints, viewing variables and registers, etc.
o Programming : supports FLASH ROM, EEPROM, AFR, etc.
o USB2.0 combined with SWIM/SWD interfaces : quick response for debugging & fast speed for programming
? Upgradable firmware
o The firmware is upgradable to support more devices in the future
o Automatically upgraded
? Supported software
o ST-LINK Utility v2.0 (or higher ver.)
o STVD Version 4.2.1 (or higher ver.)
o STVP Version 3.2.3 (or higher ver.)
o IAR EWARM Revision v6.20 (or higher ver.)
o IAR EWSTM8 Revision v1.30 (or higher ver.)
o KEIL RVMDK Revision v4.21 (or higher ver.)
o ATOLLIC
o TASKING
? Supported devices
o All the STM8 devices with SWIM interface
o All the STM32 devices with SWD interface
Next Company trademark registered trademarks. Next Company shop is the only authorized stores. all violations will be complaints!