Description
The ST-LINK is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The SWIM and JTAG/SWD interface is used to communicate with the STM8 or STM32 microcontroller located on your own application board.
On the PC side, the USB full speed interface is used to communicate with:
ST Visual Develop (STVD) or ST Visual Program (STVP) software from
STMicroelectronic’s for the STM8,
ATOLLIC, IAR and KEIL Integrated Development Environments for the STM32.
Key Features
5 V power supplied by USB connector
USB 2.0 full speed interface compatible
USB standard A to micro cable provided
SWIM specific features:
1.65 V to 5.5 V application voltage supported on SWIM interface
SWIM low speed and high speed modes supported
SWIM programming speed rate:
9.7 Kbytes/s in low speed
12.8 Kbytes/s in high speed
SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector
JTAG/SWD specific features:
3 V to 3.6 V application voltage supported on JTAG/SWD interface and 5 V tolerant inputs
JTAG/SWD cable provided for connection to a standard JTAG 20-pin pitch 2.54 MM connector
Direct firmware update feature supported
Status LED which blinks during communication with PC
Operating temperature 0 to 50 degree
Distribution List:
1 * ST-LINK
1 * USB type A to micro cable
1 * 20-pin JTAG/SWD flat ribbon
1 * 4-pin SWIM separate-wires cable